CGB蓄电池注意事项
1、请根据用途或设计要求，正确选择蓄电池的型号、规格和安装使用方式。
2、不同厂家、不同型号、不同容量、不同性能的蓄电池不能混合使用。
3、蓄电池充电方式以恒压限流为宜，25℃环境温度条件下：
浮充使用时，充电电压为2.23~2.30V/单格，最大电流不限；循环使用时，充电电压为2.40~2.50V/单格；均充电压为2.35～2.40V/单格；最大电流为0.3C。
4、使用蓄电池时，根据使用的环境温度变化，充电电压相应调整，浮充使用时温度补偿系数为-3mV/（℃单格），即环境温度每升高1℃，充电电压降低-3mV/单格；反之，环境温度每下降1℃，充电电压升高-3mV/单格；循环使用时，为-5mV/（℃单格）；均充使用时为-4mV/（℃单格）。
5、蓄电池不可倒置或装入密封容器中使用，需尽量做到通风良好。
6、蓄电池不可靠近火源或在高温的地方使用和贮存，还应避免太阳直射。
7、蓄电池不可与有机溶剂接触，以免蓄电池壳体变形或溶解。
8、蓄电池放电后长时间搁置不使用应及时充电恢复容量；使用过程中不要过放电，以免因蓄电池极板过度硫酸盐化而影响容量和寿命。
9、蓄电池应避免过充电，过充电会使安全阀频繁开启，造成蓄电池过量失水而影响寿命。
10、蓄电池极柱端子“+”为正极，“-”为负极，不得接错或短路。
11、安装或使用蓄电池应保持干净、整洁，连接的部件必须牢固，以免因接触不良引起危害。
12、请不要随意丢弃或拆解蓄电池，不要将蓄电池扔入火中，以免引起环境和爆炸等事故。
1、According to the use or design requirements,The correctchoice of battery model,Specifications and installation and usemode.
2、Different manufacturers,Different models,Differentcapacity,Different performance of the battery can not bemixed.
3、Battery charging mode with constant voltage current limitingadvisable,Under the condition of 25℃ ambient temperature:When floating charging is used,The charging voltage is2.23~2.30V/single grid, And the maximum current is notlimited;When used in circulation,The charging voltage is2.40~2.50V/single grid;The average charging voltage is2.35~2.40V/single grid;The maximum current is 0.3c.
4、When using the battery,According to the use ofenvironmental temperature change,Charging voltageadjustment accordingly,Floating when using coefficient oftemperature compensation for-3mv/℃ (single),Namelyenvironmental temperature rise per 1℃,Charging voltagereduce to-3mv/single;On the other hand,The environmenttemperature drop per 1℃, Charging voltage ríse-3mv/single;Cycle when used for-5mv/(℃,the single),All chargewhen using for-4mv/(℃,the single).
5、The battery should not be inverted or put into a sealedcontainer for use,Should try to do a good ventilation.
6、The battery should not be close to the source of fire or in ahigh temperature place to use and storage,But also shouldavoid direct sunlight.
7、The battery should not be in contact with organic solvents,Soas to avoid the battery shell deformation or dissolution.
8、Battery discharge after a long time to use should not be timelycharging capacity recovery;Do not over discharge in theprocess of use,So as not to affect the capacity and life of thebattery plate due to excessive sulfuric acid.
9、The battery should avaid overcharging,Overcharging willmake the safety valve open frequently, Resulting in excessive water loss of the battery and affect the life.
10、Battery pole column terminal "+" is a positive pole, "-" is anegative pole,not wrong or short circuit.
11、The installation or use of battery should be kept clean,Clean,Connected parts must be strong,So as not to cause harmdue to poor contact.
12、Please do not discard or disassemble the battery,Do notthrow the battery into the fire,So as not to cause environmentaland explosion accidents.c Control System,PortableInstruments,Electric Instruments,Railways And Ship.